How do you remove a boat throttle control?

Place the control handle in the throttle-only position. Push “In” on button and place control handle forward. Throttle-only but- ton can now be removed. If button cannot be re- moved with fingers, use a small screwdriver and pry out gently.Click to see full answer. Herein, how do boat throttle controls work?The throttle control is a lever that can be pressed forward to increase the speed of the boat. When the throttle level is pushed forward, it opens the engine throttle in the outboard, which means that more air and fuel is being allowed into the combustion chamber at a higher rate of frequency.Beside above, how do you adjust the throttle cable on a Suzuki outboard? Re: Suzuki Throttle Cable Adjustment Get a helper to push the throttle lever forward all the way and open the motor side up by hand, then tighten down the adjustment screw, then return it to neutral and make sure the throttle on the motor has relaxed all the way down to its resting position. Just so, how much does it cost to replace throttle cable on a boat? Typically the throttle cables don’t get exposed to the elements enough to need replacing. If you go to a dealer, my guess on cost would be the following ($760 total): $80 per cable ($160 total) -from Yamahasportsplaza – I had a dealer quote me double that once!How do you put on hot feet? ** No special tools needed. Step 1: Remove motor cowl and disconnect the throttle cable from throttle arm and anchor trunion. Step 3: Run new cable down thru hull and out to motor. Step 5: Drill the holes. Step 7: Sit hot foot back in its spot and put silicone on each screw and screw it to the floor.

ncG1vNJzZmivp6x7pLHLnpmroaSesrSu1LOxZ5ufonuotI6hprBllKR6urvUZqmepZ%2Brsm6tjJummqxdqbWzu9Oto55lk6S7tb7OpWY%3D